Removal

SEAT: FRONT SEAT ASSEMBLY (for Manual Seat): REMOVAL

REMOVAL
CAUTION:
- Always wear safety gloves because the edges of the seatback frame and seat adjuster are sharp and may cause injury.
- Work must be started more than 90 seconds after the ignition switch is turned off and the negative (-) terminal cable is disconnected from the battery.
(The SRS is equipped with a back-up power source. If work is started within 90 seconds after disconnecting the negative (-) terminal cable of the battery, the SRS may deploy.)
HINT:
- Installation is in the reverse order of removal. However, special points concerning installation are indicated.
- Use the same procedures for the RH side and LH side.

1. DISCONNECT BATTERY NEGATIVE TERMINAL
HINT:
Service Precautions

2. REMOVE SEAT TRACK BRACKET COVER OUTER FRONT RH
(a) Disengage the 2 claws and remove the seat track bracket cover outer front RH.
3. REMOVE SEAT TRACK BRACKET COVER INNER FRONT RH
(a) Disengage the 2 claws and remove the seat track bracket cover inner front RH.
4. REMOVE FRONT SEAT TRACK COVER RH REAR OUTER
(a) Disengage the 2 claws and remove the front seat track cover RH rear outer.
5. REMOVE SEAT TRACK BRACKET COVER INNER RH
(a) Disengage the 2 claws and remove the seat track bracket cover inner RH.
6. REMOVE FRONT RH SEAT ASSEMBLY
(a) Remove the 4 bolts.
(b) Disconnect the connectors and clamp.
(c) Remove the front RH seat assembly.