Navigation System

TROUBLE CODE CHART

Part 1:

Part 2:

Physical address: 110 Multi display

*1 : Check if the operation in Touch Point Check or Touch Switch Check screen is normal. If it operates without any problem, see how things go for a while.
Although this code is defined as Panel Switch Error, there are touch switches only on the display. If the internal communication is erroneous, however , this code is stored.

*2 : Even if no failure is detected, it may be stored depending on the battery condition or voltage for starting an engine.
*3: It is stored when 180 seconds has passed after the power supply connector is pulled out after engine start.
*4 : It may be stored when the engine key is turned again 1 minute. after engine start.
*5 : It may be stored when the engine key is turned again after engine start.

Part 1:

Part 2:

Part 3:

Physical address: 190 Radio receiver assembly

*2 : Even if no failure is detected, it may be stored depending on the battery condition or voltage for starting an engine.
*3 : It is stored when 180 seconds has passed after the power supply connector is pulled out after engine start.
*4 : It may be stored when the engine key is turned again 1 minute. after engine start.
*5 : It may be stored when the engine key is turned again after engine start.
*6 : When 210 seconds has passed after pulling out the power supply connector of the master component with the ignition switch in ACC or ON, this code is stored.

Part 1:

Physical address: 178 Navigation ECU

*6 : When 210 seconds has passed after pulling out the power supply connector of the master component with the ignition switch in ACC or ON, this code is stored.