Extension Housing: Service and Repair

REPLACEMENT
1. Remove reverse restrict pin.
a. Using a hexagon wrench, remove the screw plug.
b. Using a pin punch and hammer, drive out the slotted spring pin.





c. Pull off the lever housing and slide out the shaft.
2. Inspect reverse restrict pin. Turn and push the reverse restrict pin by hand. Check for smooth operation.





3. Install reverse restrict pin.
a. Install the lever housing.
b. Using a pin punch and hammer, drive in the slotted spring pin, as shown.
c. Apply THREE BOND 1 LOCTITE 242, or equivalent sealant, to the plug.
d. Install and torque the screw plug.
Torque to: 25 N.m (18 ft. lbs.)