Crankshaft Position Sensor: Service and Repair

COMPONENTS FOR REMOVAL AND INSTALLATION

CRANKSHAFT POSITION SENSOR REMOVAL
1. DISCONNECT CRANKSHAFT POSITION SENSOR CONNECTOR FROM GENERATOR DRIVE BELT ADJUSTING BAR
2. REMOVE RH FENDER APRON SEAL
3. REMOVE NO.1 TIMING BELT COVER
4. REMOVE CRANKSHAFT POSITION SENSOR





- Remove the bolt and disconnect the crankshaft position sensor.

Torque: 9.5 N.m (95 Kgf.cm, 82 in.lbf)

CRANKSHAFT POSITION SENSOR INSTALLATION

INSTALLATION HINT: Installation is in the reverse order of removal.