DTC 22

DTC 22 SRS Warning Light System Malfunction

CIRCUIT DESCRIPTION
The SRS warning light is located on the cluster finish panel.

When the SRS is normal,the SRS warning light lights up for approx. 6 seconds after the ignition switch is turned from LOCK position to ACC or ON position, and then turns off automatically.

If there is a malfunction in the SRS, the SRS warning light lights up to inform the driver of the abnormality.

When terminals Tc and E1 of the DLC1 or DLC2 are connected, the DTC is displayed by the blinking of the SRS warning light.

The SRS warning light circuit is equipped with an electrical connection check mechanism which detects when the connector to the center airbag sensor assembly is not properly connected.

If the connector to the center airbag sensor assembly is not properly connected, the SRS warning light will not light up.

DTC 22 is recorded when a malfunction occurs in the SRS warning light system. If an OPEN malfunction occurs in the SRS warning light system, the SRS warning light does not light up, so that until the malfunction is repaired, the DTC (including code 22) cannot be confirmed.





DETECTING CONDITION





WIRING DIAGRAM

INSPECTION PROCEDURE
Troubleshooting for this system is different for when the SRS warning light does not light up and for when DTC 22 is output. Confirm the problem symptoms first before selecting the appropriate troubleshooting procedure.

Step 1:

Step 2:

Step 3:

Step 4:

Step 5:

Step 6:

HINT: If SRS warning light does not light up, do the following troubleshooting:

Step 1:

HINT: If DTC 22 is output, do the following troubleshooting: