Automatic Transmission Fluid
REPLACEMENT1) Lift up the vehicle.
2) Remove the drain plug (ATF) and completely drain the ATF.
CAUTION:
^ Immediately after the vehicle has been running or after idling for a long time, the ATF will be hot. Be careful not to receive burns.
^ Be careful not to spill the ATF on the exhaust pipe to prevent it from emitting smoke or causing fire. If ATF is spilled on the exhaust pipe, wipe it off completely.
3) Check the ATF condition. Condition Check
4) Tighten the drain plug (ATF).
NOTE:
Use a new gasket.
Tightening torque:
25 Nm (2.5 kgf-m, 18.4 ft-lb)
5) Lower the vehicle.
6) Pour ATF from the oil charge pipe.
CAUTION:
Be sure to use the recommended or equivalent ATF. Using material except recommended one or substitute would cause trouble.
Capacity:
Refill with the same amount of ATF that was drained from drain plug hole.
Capacity when transmission is overhauled:
9.3 - 9.6 L (9.8 - 10.1 US qt, 8.2 - 8.4 Imp qt)
7) Bleed the air of control valve. Procedures
8) Check the level and leaks of ATF. Inspection