Rear Gate Latch and Actuator Assembly

Rear Gate Latch and Actuator Assembly

REMOVAL

1. Disconnect the ground cable from battery.
2. Remove the trim panel - rear gate.
3. Remove the latch and actuator - rear gate.
1. Disconnect the connector.
2. Remove the bolts, and remove the latch and actuator - rear gate.






INSTALLATION

Install each part in the reverse order of removal.

Tightening torque:
T1: 7.5 N.m (0.76 kgf-m, 5.5 ft-lb)
T2: 25 N.m (2.55 kgf-m, 18.4 ft-lb)