Disassembly

TX6A AUTOMATIC TRANSMISSION / TRANSAXLE: SHIFT LEVER: DISASSEMBLY; 2013 MY FR-S [03/2012 -]

1. REMOVE FLOOR SHIFT SHIFT LEVER HOUSING

(a) Using a screw driver, disengage the claw and disconnect the connector.

(b) Using a thin-bladed screwdriver, lift up the terminal retainer of the transmission control switch connector to release the lock.

(d) Remove the shift lever lock nut and shift lever lock pin.

(e) Disengage the 2 claws and remove the floor shift shift lever housing from the base plate.

2. REMOVE SHIFT LOCK CONTROL UNIT ASSEMBLY

(a) Remove the pin then remove the shift lock release arm and shift lock control unit assembly.

(b) Remove the shift lock release arm from the shift lock control unit assembly.

3. REMOVE DETENT ROD

(a) Remove the detent lock clamp.

(b) Remove the detent lock spring and detent lock rod.

(c) Remove the cushion detent lock from the detent lock rod.

(d) Remove the bush detent lock.

4. REMOVE SHIFT LEVER PLATE GROMMET

(a) Remove the shift lever plate grommet from the base plate.

5. REMOVE FLOOR SHIFT CONTROL SHAFT LEVER

(a) Using a pin punch (3 mm (0.118 in.)) and a hammer, drive out the spring pin.

(b) Remove the floor shift control shaft lever from the base plate.

6. REMOVE FLOOR SHIFT CONTROL SELECT LEVER

(a) Remove the floor shift support bracket and the floor shift control shaft lever from the base plate.

7. REMOVE FLOOR SHIFT SUPPORT BRACKET

(a) Remove the floor shift support bracket from the floor shift control shaft lever.

(b) Remove the pin and the spring from the floor shift support bracket.

8. REMOVE SHIFT LEVER SEAT SUB-ASSEMBLY

(a) Remove the 4 spacer plates and shift lever seat sub-assembly from the base plate.

9. REMOVE FLOOR SHIFT CONNECTING ROD SWIVEL

(a) Remove the clip, 2 washers, grommet, pin and floor shift connecting rod swivel from the select lever.