Installation

REAR SUSPENSION: TOE CONTROL LINK: INSTALLATION; 2013 MY FR-S [03/2012 -]

HINT
* The procedure listed below is for the LH side.
* Use the same procedure for the RH and LH sides.

1. TEMPORARILY INSTALL TOE CONTROL LINK SUB-ASSEMBLY LH

(a) Install the toe control link sub-assembly LH and insert the toe adjust cam from the front of the vehicle. Then, install the rear No. 2 suspension toe adjust plate and temporarily install the new nut.

NOTICE:
Align the matchmarks on the rear suspension member and the rear No. 2 suspension toe adjust plate.

(b) Install the rear suspension toe control link sub-assembly LH to the rear axle carrier side with a nut.

Torque : 60 Nm (612 kgf-cm, 44 ft-lbf)

(c) Install the new snap pin.

2. TEMPORARILY INSTALL REAR NO. 1 SUSPENSION ARM ASSEMBLY LH Installation

3. STABILIZE SUSPENSION Installation

4. FULLY TIGHTEN TOE CONTROL LINK SUB-ASSEMBLY LH

(a) Fully tighten the nut on the rear suspension member side.

Torque : 100 Nm (1020 kgf-cm, 74 ft-lbf)

NOTICE:
Check that the matchmarks on the rear suspension member and the rear No. 2 suspension toe adjust plate are aligned.

5. FULLY TIGHTEN REAR NO. 1 SUSPENSION ARM ASSEMBLY LH Installation

6. INSTALL REAR WHEEL

Torque : 120 Nm (1224 kgf-cm, 89 ft-lbf)

7. INSPECT AND ADJUST REAR WHEEL ALIGNMENT

Rear Wheel Alignment

8. VSC SENSOR NEUTRAL MEMORIZATION

Programming and Relearning