Installation

FA20 ENGINE MECHANICAL: FRONT CRANKSHAFT OIL SEAL: INSTALLATION; 2013 MY FR-S [03/2012 -]

1. INSTALL TIMING CHAIN OR BELT COVER OIL SEAL

(a) Apply engine oil to the lip of a new timing chain or belt cover oil seal.

NOTICE:
* Keep the lip free of foreign matter.
* Do not apply engine oil to the dust seal section.

(b) Using SST and a hammer, tap in the timing chain or belt cover oil seal until its surface is flush with the timing chain cover edge.





SST : 09223-22010

NOTICE:
* Keep the lip free of foreign matter.
* Do not tap the oil seal at an angle.

HINT
Alternatively, the tapping depth of the timing chain or belt cover oil seal can be 0 to -1.0 mm (0 to -0.039 in.) from the timing chain cover end surface.

2. INSTALL CRANKSHAFT PULLEY

(a) Install the crankshaft pulley spacer.

(b) Install a new O-ring to the crankshaft pulley spacer.

(c) Install the crankshaft pulley while aligning the knock hole of the pulley with the knock pin on the crankshaft pulley spacer.









(d) Apply engine oil to the pulley bolt.

(e) Using SST, hold the crankshaft pulley and tighten the pulley bolt.

SST : 09960-10010

09962-01000

09963-01000

Torque : 20 Nm (204 kgf-cm, 15 ft-lbf)

(f) Using a marker, draw the reference line (A) on the crank pulley bolt and also the reference line (B) on the crank pulley according to the line engraved around the crank pulley bolt head as shown in the illustration.









HINT
There are carved lines on the pulley bolt head every 90°.

(g) Using SST, hold the crankshaft pulley, and tighten the pulley bolt by 90° until the reference lines A and B are aligned.









SST : 09960-10010

09962-01000

09963-01000

3. INSTALL FAN AND GENERATOR V BELT

Installation