Fuel Filler Hose: Service and Repair
REMOVAL1. Disconnect the battery ground cable. For additional information, refer to Battery.
2. Drain the fuel tank.
3. Remove the screws.
CAUTION: Do not damage retainer ring during removal or the cap may not seal.
4. Raise the vehicle. For additional information, refer to Maintenance/Service and Repair.
5. Remove the LH rear wheel and tire assembly.
6. Disconnect the vapor recirculation tube connector.
7. Remove the screw.
CAUTION: The dogpoint screw has a blunt end and must be used in this application.
8. Remove the fuel tank filler pipe.
1 Slide the fuel tank filler pipe into the tank enough to obtain clearance.
2 Rotate counterclockwise 1/2 turn and remove the fuel tank filler pipe.
CAUTION: Exercise care not to damage grommet or check valve at end of pipe.
NOTE: If unable to obtain sufficient clearance for removal, the tank straps may have to be loosened.
INSTALLATION
1. Install the fuel tank filler pipe in the fuel tank.
NOTE: Lubricate the fuel tank filler pipe end with petroleum meeting Ford specification ESW-M1C115-A or ESB-M1C99-A.
2. Install the dogpoint screw.
NOTE: Screw has a blunt end and must be used in this application.
3. Install the screws.
NOTE: Attach strap for cap at 4:00 o'clock position.
4. Connect the vapor recirculation hose.