Disconnect/Connect Engine Wire Harness

Removal
- Disconnect ground cable at battery (W10) below rear seat on right.
- Remove cover over engine component compartment.
- Unplug connector (arrow) at control module (N10-1) to gain access to plug connection (X22)
- Separate plug connection (X22)
- Unplug connector (arrow) at control module (N3/10) of engine management system (ME-SFI).
- Unplug connector (arrow) at relay unit (K40).





- Unbolt shields over terminal block (X4) in right footwell and electric transmission control unit (Y3/6).
- Unbolt cable (circuit 30) with bracket at terminal block (X4) (right footwell) and electric transmission control unit (Y3/6).
- Unbolt power steering pump interference suppression ground (W30/2).
- Unbolt ground cable (W11/1) at engine.





- Unbolt wiring at generator (G2).

Installation
Reverse procedure to install.