Parking Brake Lever: Service and Repair

PARKING BRAKE LEVER REMOVAL/INSTALLATION

1. Remove the main silencer. Service and Repair

2. Remove the heat insulator.

3. Remove the under cover (rear).

4. Remove the second-row seat. Second-Row Seat Removal/Installation

5. Remove the front seat. Front Seat Removal/Installation

6. Remove the center console. Center Console Removal/Installation

7. Remove the center console bracket as shown in the figure.






8. Remove the front scuff plate. Front Scuff Plate Removal/Installation

9. Remove the front side trim. Front Side Trim Removal/Installation

10. Remove the rear scuff plate. Rear Scuff Plate Removal/Installation

11. Remove the B-pillar lower trim. B-Pillar Lower Trim Removal/Installation

12. Remove in the order indicated in the table.

13. Install in the reverse order of removal.

14. After installation, inspect the parking brake lever stroke. Testing and Inspection










Front Parking Brake Cable Removal Note

1. Lift the floor covering around the parking brake lever installation area.

2. Remove the front parking brake cable installation bolts through the parking brake lever installation hole of the floor covering.

3. Remove the front parking brake cable through the parking brake lever installation hole of the floor covering.

Rear Parking Brake Cable Installation Note

1. Pass the rear parking brake cable inside the rear ABS wheel-speed sensor wiring harness as shown in the figure.






2. Install the rear parking brake cable.

3. Verify that the end of the rear parking brake cable outer end is out of the caliper as shown in the figure.