Stall Speed Test

Caution: Perform the line pressure test at engine idling prior to performing the test at engine stall. It line pressure Is low at Idle, do not perform the test at engine stall or further transaxle damage will occur.

1. Perform mechanical system test preparation.
2. Connect a tachometer.
3. Start the engine.
4. Shift the selector lever to D range.

Caution:
^ Do not maintain WOT in any gear range for more than 5 seconds or transaxle damage will occur.
^ If engine speed recorded by the tachometer exceeds maximum specified rpm, release accelerator pedal immediately. Clutch or band slippage is indicator.

5. Firmly depress the brake pedal with the left foot, and gently depress the accelerator pedal with the right.
6. When the engine speed no longer increases, quickly read the engine speed and release the accelerator pedal.
7. Shift the selector to N position and let the engine idle for 1 minute or more to cool the ATF.
8. Perform stall tests for the remaining ranges in the same manner.
(1) D range
(2) R position
(3) 2 range
(4) 1 range
Engine stall speed
ATF temperature: 60 - 70°C (140 - 158°F) Turn off all electrical loads
Engine stall speed: 2,000 - 2,500 rpm
9. Turn off the engine.





Evaluation chart for stall test