Flow Chart 2 - Lamp Flashes Three Times

Flowchart No. 2








Step 1
- Measure the battery positive voltage.








Step 2
- Check the ABS 10 A and Engine 10 A fuses in the fuse block and the FUEL INJ 30 A fuse in main fuse block No.1

Step 3
- Disconnect the negative battery cable.








- Make sure the diagnostic module connectors are properly connected.

Step 4





- Disconnect the diagnostic module connector and connect the SST to it as shown in the figure.
- Connect the negative battery cable.
- Turn the ignition switch to ON.





- Measure the voltage at terminals 1A (B/W), 2M (LG) and 2N (W/G) of the diagnostic module connector.