Seat Track

Seat Track

Removal and Installation

WARNING: Never disassemble or tamper with safety belt buckle/retractor pretensioners or adaptive load limiting retractors or probe the electrical connectors. Failure to follow this instruction may result in the accidental deployment of the safety belt pretensioners or adaptive load limiting retractors which increases the risk of serious personal injury or death.

WARNING: Never probe the electrical connectors on air bag, Safety Canopy(R) or side air curtain modules. Failure to follow this instruction may result in the accidental deployment of these modules, which increases the risk of serious personal injury or death.

NOTE: For component identification and locations, refer to Seat - Exploded View, Front Seat - Exploded View, Front.

1. Remove the front seat. For additional information, refer to Seat - Front Seat - Front.

2. Remove the front seat backrest. For additional information, refer to Seat Backrest - Front Seat Backrest - Front.

3. Remove the pin-type retainers (1 shown) and release all the J-clips. Remove the cushion trim cover and cushion foam pad.





4. NOTE: Note driver seat wire harness routing for installation.

Remove the cushion wire harness. For correct passenger seat wire harness routing, refer to Seat Wire Harness Routing Seat Wire Harness Routing.

5. To install, reverse the removal procedure.
- If a new seat track has been installed on a driver seat with memory, operate the seat in all directions through the full range of travel to set soft stops and avoid a premature stopping point occurrence after the vehicle is returned to the customer.

6. Install the front seat backrest. For additional information, refer to Seat Backrest - Front Seat Backrest - Front.

7. Install the front seat. For additional information, refer to Seat - Front Seat - Front.