Cluster Finish Panel

Instrument Cluster Finish Panel

Removal and Installation

1. Tilt the steering wheel to the full downward position.

2. Remove the 2 steering column opening trim panel screws.

3. Remove the steering column opening trim panel.
- Pull the steering column opening trim panel rearward to release the retaining clips.

4. Remove the LH instrument panel finish panel. For additional information, refer to Instrument Panel Finish Panel - LH Instrument Panel Finish Panel - LH.

5. Remove the center instrument panel finish panel. For additional information, refer to Instrument Panel Finish Panel - Center Instrument Panel Finish Panel - Center.

6. Remove the ignition switch bezel.

7. Remove the 4 headlamp switch screws.

8. Remove the headlamp switch.
- Disconnect the electrical connector.

9. Remove the 2 instrument cluster finish panel screws.

10. Remove the instrument cluster finish panel.

11. To install, reverse the removal procedure.
- Transfer parts as needed.

- To install, make sure to align the trim panel retaining clips to the retaining clip holes in the instrument panel.