Test P: The Heated Seat Is Inoperative - Right Rear

PINPOINT TEST P: THE HEATED SEAT IS INOPERATIVE - RIGHT REAR

Normal Operation
The right rear heated seat module receives voltage feed on circuit 1445 (RD/GN), ignition voltage feed on circuit 1040 (RD/BK) and is supplied ground on circuit 57 (BK). When the heated seat control switch is pressed with the ignition switch in RUN or START, a ground signal is sent to the heated seat module on circuit 581 (RD) to command the system ON or OFF in HI heat mode or circuit 1256 (WH/YE) to command the system ON or OFF in LOW heat mode. When commanded ON, a ground signal is supplied to the heated seat switch from the heated seat module on either circuit 580 (BN) (HIGH heat mode) or circuit 579 (BK/OG) (LOW heat mode) illuminating the switch indicator. The heated seat module also supplies voltage to the cushion and backrest heater mats on circuit 1064 (YE/LB) and ground to the heater mats on circuit 1065 (WH/LB). The cushion and backrest heater mats are connected in series and operate together. Temperature is maintained by the heated seat module using a sensor contained within the cushion heater mat. The heated seat module supplies a reference voltage to the temperature sensor on circuit 1060 (BK/LB) and monitors the return signal from the temperature sensor on circuit 1061 (BN/LB) for adjusting the current flow to the heater mats. The heated seat module is designed to remain ON, heating the seat and maintaining temperature until switched OFF or the time-out period occurs.

This pinpoint test is intended to diagnose the following:
- Fuse
- Wiring, terminals or connectors
- Heater mat
- Heated seat switch
- Heated seat module

P1-P2:

P3-P5:

P6-P8:

P8-P10:

P10-P11:

P12-P14:

P14-P15:

P16: