Test G: The Memory SET Switch Indicator Is Inoperative/Always On

PINPOINT TEST G: THE MEMORY SET SWITCH INDICATOR IS INOPERATIVE/ALWAYS ON

Normal Operation
A 3-lead sensor is attached to each motor on the memory seat track and recliner assembly. The sensor circuits are connected to the driver seat module (DSM) which supplies the sensor voltage and receives the sensor signals. The DSM receives data from the memory seat position sensors to monitor the positions of the seat track and recliner motors. This motor position data is stored when the DSM receives a SET switch input signal and recalled when it receives a RECALL switch input signal. The driver door module (DDM) is directly connected to the memory SET/RECALL switch and transmits the switch signal data to the DSM using the standard corporate protocol (SCP) communication bus. The DSM also receives memory recall signals from the remote transmitter over the SCP communication bus transmitted by the lighting control module (LCM).







This pinpoint test is intended to diagnose the following:
- Wiring, terminals or connectors
- Driver seat control switch
- DDM

G1-G2:

G2-G5:

G5 Continued: