Roof Opening Panel Motor

ROOF OPENING PANEL MOTOR

Removal and Installation

1. NOTE: Make sure the roof opening panel glass does not move during the motor removal or installation. The roof opening panel timing may be affected and cause the roof opening panel glass to bind.

Remove the overhead console.
- Disconnect the 4 electrical connectors.

2. Disconnect the roof opening panel motor electrical connector.
3. Remove the 3 screws and the roof opening panel motor.
- To install, tighten to 3 Nm (27 lb-in).

4. NOTE: If the roof opening panel glass moved while the roof opening panel motor was removed, the roof opening panel motor must be initialized.

To install, reverse the removal procedure.
- If necessary, initialize the roof opening panel motor.