Roof Opening Panel Motor

ROOF OPENING PANEL MOTOR

Removal and Installation

1. NOTE: Make sure the roof opening panel glass assembly is not moved during motor removal or installation. The roof opening panel assembly timing may be affected and cause the roof opening panel assembly to bind or be damaged.

Remove the headliner.

2. Remove the 3 roof opening panel motor screws, disconnect the electrical connector, and remove the motor assembly.
- To install, tighten to 3 Nm (27 lb-in).

3. NOTE: If the roof opening glass assembly was moved while the roof opening panel motor was removed, the timing must be reset.

To install, reverse the removal procedure.