Installation
SUSPENSION: REAR UPPER ARM: INSTALLATION
HINT
* Use the same procedures for the RH side and LH side.
* The procedures listed below are for the LH side.
* A bolt without a torque specification is shown in the standard bolt chart Standard Bolt - Specified Torque For Standard Bolts.
1. TEMPORARILY CONNECT PNEUMATIC CYLINDER WITH REAR SHOCK ABSORBER ASSEMBLY LH
(a) Temporarily connect the pneumatic cylinder lower side with a new nut and washer to the axle carrier.
2. TEMPORARILY INSTALL REAR UPPER NO. 1 CONTROL ARM ASSEMBLY LH
(a) Temporarily install the control arm with the bolt, nut and washer to the suspension member.
(b) Install the stud of the control arm, and temporarily install a new nut to the axle carrier.
HINT
Push the axle carrier downward.
3. TIGHTEN REAR UPPER NO. 1 CONTROL ARM ASSEMBLY LH
(a) Tighten the nut on the control arm.
Torque : 150 Nm (1530 kgf-cm, 111 ft-lbf)
(b) Tighten the nut on the control arm.
Torque : 160 Nm (1632 kgf-cm, 118 ft-lbf)
4. TEMPORARILY INSTALL REAR UPPER NO. 2 CONTROL ARM ASSEMBLY LH
(a) Temporarily install the control arm with the bolt, nut and washer to the suspension member.
(b) Install the stud of the control arm, and temporarily install a new nut to the axle carrier.
HINT
Push the axle carrier downward.
5. TIGHTEN REAR UPPER NO. 2 CONTROL ARM ASSEMBLY LH
(a) Tighten the nut on the rear control arm.
Torque : 225 Nm (2294 kgf-cm, 166 ft-lbf)
(b) Tighten the nut on the rear control arm.
Torque : 160 Nm (1632 kgf-cm, 118 ft-lbf)
6. TEMPORARILY INSTALL REAR NO. 2 SUSPENSION ARM ASSEMBLY LH Installation
7. CONNECT TOE CONTROL LINK SUB-ASSEMBLY LH Installation
8. CONNECT REAR NO. 1 SUSPENSION ARM ASSEMBLY LH Installation
9. INSTALL REAR DISC BRAKE CALIPER ASSEMBLY LH Installation
10. STABILIZE SUSPENSION Installation
11. TIGHTEN REAR NO. 2 SUSPENSION ARM ASSEMBLY LH Installation
12. TIGHTEN PNEUMATIC CYLINDER WITH REAR SHOCK ABSORBER ASSEMBLY LH
(a) Tighten the nut on the axle carrier.
Torque : 80 Nm (816 kgf-cm, 59 ft-lbf)
13. INSTALL REAR STABILIZER LINK ASSEMBLY LH Installation
14. INSTALL REAR WHEEL
Torque : 140 Nm (1428 kgf-cm, 103 ft-lbf)
15. CHECK SUSPENSION CONTROL SYSTEM
(a) Check the suspension control system Adjustments.
16. INSPECT AND ADJUST REAR WHEEL ALIGNMENT
(a) Inspect and adjust the rear wheel alignment Rear Wheel Alignment.
17. ADJUST HEADLIGHT ASSEMBLY
(a) for LED headlight:
Adjust the headlight (for LED Headlight).
(b) for HID headlight:
Adjust the headlight (for HID Headlight).
18. ADJUST OBJECT RECOGNITION CAMERA
(a) Adjust the object recognition camera Adjustments.