Installation

SUPPLEMENTAL RESTRAINT SYSTEM: STEERING PAD: INSTALLATION

1. INSTALL STEERING PAD

(a) Check that the power switch is off.

(b) Check that the negative (-) battery terminal is disconnected.

CAUTION:
Wait for at least 90 seconds after disconnecting the cable to prevent airbag deployment.

(c) Connect the 2 airbag connectors to the steering pad.





NOTICE:
When handling the airbag connector, take care not to damage the airbag wire harness.

(d) Connect the horn connector to the steering pad.

(e) Confirm that the circumference groove of the "TORX" screw fits in the screw case, and place the steering pad onto the steering wheel assembly.





(f) Using a "TORX" socket wrench (T30), tighten the 2 "TORX" screws.

Torque : 8.8 Nm (90 kgf-cm, 78 in-lbf)

2. INSTALL LOWER NO. 3 STEERING WHEEL COVER

(a) Install the lower No. 3 steering wheel cover with the claw.





3. INSTALL LOWER NO. 2 STEERING WHEEL COVER

(a) Install the lower No. 2 steering wheel cover with the claw.





4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

5. INSPECT STEERING PAD

(a) With the steering pad installed on the vehicle, perform a visual check. If there are any defects as mentioned below, replace the steering pad with a new one:

Cuts, minute cracks or marked discoloration on the steering pad top surface or in the grooved portion.





(b) Make sure that the horn sounds.

HINT
If the horn does not sound, inspect the horn system.

6. CHECK SRS WARNING LIGHT

(a) Check the SRS warning light Diagnosis System.