Installation

SUPPLEMENTAL RESTRAINT SYSTEM: DRIVER SIDE KNEE AIRBAG ASSEMBLY: INSTALLATION

1. INSTALL DRIVER SIDE KNEE AIRBAG ASSEMBLY

(a) Connect the connector.





NOTICE:
When handling the airbag connector, take care not to damage the airbag wire harness.

(b) Attach the clip to install the driver side knee airbag.

(c) Install the 4 bolts.

Torque : 10 Nm (102 kgf-cm, 7 ft-lbf)

(d) Attach the claw to install the lock lever.

(e) Install the control cable.

2. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY Installation

3. INSTALL NO. 1 INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY Installation

4. INSTALL NO. 1 INSTRUMENT CLUSTER MOULDING Installation

5. INSTALL INSTRUMENT SIDE PANEL LH Installation

6. INSTALL INSTRUMENT PANEL FINISH PANEL END LH Removal

7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

8. INSTALL BATTERY SERVICE HOLE COVER LH Installation

9. INSTALL DECK TRIM SIDE BOARD LH (w/o Spare Tire) Installation

10. INSTALL LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY Installation

11. CHECK SRS WARNING LIGHT

(a) Check the SRS warning light Initialization.