Removal

NAVIGATION / MULTI INFO DISPLAY: MULTI-DISPLAY: REMOVAL

1. PRECAUTION

NOTICE:
* After the engine switch is turned off, the display and navigation module display (HDD navigation system) records various types of memory and settings. As a result, after turning the engine switch off, make sure to wait at least 60 seconds before disconnecting the cable from the negative (-) battery terminal.
* A hard disk drive (HDD) is built into the display and navigation module display (HDD navigation system) to store map data etc. which will be used for the navigation system. Therefore, make sure to read all of the precautions thoroughly before handling the display and navigation module display (HDD navigation system).
* When removing or installing the hard disk drive, eliminate static electricity by touching the vehicle body to prevent components from being damaged.
2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

3. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY Removal

4. REMOVE UPPER NO. 1 CONSOLE PANEL GARNISH Removal

5. REMOVE UPPER NO. 2 CONSOLE PANEL GARNISH Removal

6. REMOVE CONSOLE PANEL SUB-ASSEMBLY Removal

7. REMOVE FRONT ASH RECEPTACLE ASSEMBLY Removal

8. REMOVE NO. 3 INSTRUMENT PANEL REGISTER ASSEMBLY Removal

9. REMOVE CENTER LOWER INSTRUMENT CLUSTER FINISH PANEL Removal

10. REMOVE DISPLAY AND NAVIGATION MODULE DISPLAY WITH RADIO RECEIVER ASSEMBLY Removal

11. REMOVE HARD DISK DRIVE Removal

12. REMOVE NO. 1 RADIO BRACKET Removal

13. REMOVE NO. 2 RADIO BRACKET Removal

14. REMOVE DISPLAY AND NAVIGATION MODULE DISPLAY ASSEMBLY

(a) Slide the display and navigation module display assembly in the direction shown by the arrow to remove it.





15. REMOVE CLOCK ASSEMBLY Removal

16. REMOVE DISPLAY AND NAVIGATION MODULE DISPLAY