Removal

HYBRID BATTERY CONTROL: HV RELAY ASSEMBLY: REMOVAL

REMOVAL

1. PRECAUTION
Service Precautions
2. CHECK DTC OUTPUT Removal
3. REMOVE LUGGAGE COMPARTMENT FLOOR MAT
4. REMOVE BATTERY SERVICE HOLE COVER LH Removal
5. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

6. REMOVE SERVICE PLUG GRIP Removal
7. REMOVE NO. 2 ENGINE ROOM SIDE RH COVER Removal
8. REMOVE CONNECTOR COVER ASSEMBLY Removal
9. CHECK TERMINAL VOLTAGE Removal
10. INSTALL CONNECTOR COVER ASSEMBLY Installation
11. INSTALL NO. 2 ENGINE ROOM SIDE RH COVER Installation
12. REMOVE LUGGAGE COMPARTMENT TRIM SIDE COVER RH
13. REMOVE TOOL BOX
14. REMOVE ROPE HOOK ASSEMBLY Removal
15. REMOVE LUGGAGE COMPARTMENT FRONT TRIM COVER Removal
16. INSTALL TOOL BOX
17. REMOVE NO. 3 HV BATTERY EXHAUST DUCT Removal
18. DISCONNECT FRAME WIRE Removal
19. REMOVE BATTERY BRACKET SUB-ASSEMBLY Removal
20. REMOVE BATTERY CARRIER SUB-ASSEMBLY Removal
21. REMOVE NO. 6 BATTERY CARRIER PANEL Removal
22. REMOVE HV RELAY ASSEMBLY





(a) Disconnect the 7 connectors and clamp from the HV relay assembly.
CAUTION:
Wear insulated gloves.
NOTICE:
Insulate the removed terminals with insulating tape.





(b) Remove the 3 nuts and HV relay assembly from the battery carrier.
CAUTION:
Wear insulated gloves.

23. REMOVE HIGH VOLTAGE FUSE





(a) Remove the 2 bolts and high voltage fuse.