Removal

INTERIOR: ROOF HEADLINING: REMOVAL

REMOVAL

1. REMOVE LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY

2. REMOVE BATTERY SERVICE HOLE COVER LH Battery

3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
NOTICE:
- After the power switch is turned OFF, the HDD navigation system requires approximately 6 minutes to record various types of memory and settings. As a result, after turning the power switch OFF, wait 6 minutes or more before disconnecting the cable from the negative (-) battery terminal.
- When Disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

4. REMOVE FRONT SEAT ASSEMBLY
(a) Remove the front seat Removal.
5. REMOVE REAR SEAT ASSEMBLY (for Fixed Type)
(a) Remove the rear seat Removal.
6. REMOVE REAR SEAT ASSEMBLY (for Power Seat)
(a) Remove the rear seat Removal.
7. REMOVE REAR SEAT ASSEMBLY (for Ottoman)
(a) Remove the rear seat Removal.
8. REMOVE FRONT DOOR SCUFF PLATE LH

(a) Put protective tape around the front door scuff plate.
(b) Using a moulding remover, detach the 4 clips.

(c) Detach the 7 claws and remove the front door scuff plate.
9. REMOVE FRONT DOOR SCUFF PLATE RH
HINT: Use the same procedures described for the LH side.

10. REMOVE COWL SIDE TRIM BOARD LH
(a) Detach the 3 claws and remove the cowl side trim board.
11. REMOVE COWL SIDE TRIM BOARD RH
HINT: Use the same procedures described for the LH side.

12. REMOVE FRONT PILLAR GARNISH LH

(a) Detach the 2 clips.
(b) Cut off clip A.
(c) Detach the claw and remove the front pillar garnish LH.
(d) Remove clip A from the vehicle body.

(e) Protect the curtain shield airbag assembly.
(1) Thoroughly cover the airbag with a cloth or nylon sheet and fix the ends of the cover with adhesive tape, as shown in the illustration.
NOTE: Cover the curtain shield airbag with a protective cover as soon as the front pillar garnish is removed.

13. REMOVE FRONT PILLAR GARNISH RH
HINT: Use the same procedures described for the LH side.

14. REMOVE REAR DOOR SCUFF PLATE LH

(a) Put protective tape around the rear door scuff plate.
(b) Using a moulding remover, detach the 4 clips.

(c) Detach the 7 claws and remove the rear door scuff plate.
15. REMOVE REAR DOOR SCUFF PLATE RH
HINT: Use the same procedures described for the LH side.

16. REMOVE CENTER LOWER PILLAR GARNISH LH
(a) Detach the 2 claws and 6 clips, and remove the center lower pillar garnish.
17. REMOVE CENTER LOWER PILLAR GARNISH RH
HINT: Use the same procedures described for the LH side.

18. REMOVE CENTER UPPER PILLAR GARNISH LH
(a) Remove the 2 screws.
(b) Detach the claw.
(c) Pass the front seat outer belt floor anchor through the center upper pillar garnish, and remove the center upper pillar garnish.
19. REMOVE CENTER UPPER PILLAR GARNISH RH
HINT: Use the same procedures described for the LH side.

20. REMOVE SHOULDER BELT ANCHOR COVER LH
(a) Detach the 6 claws of the cover, and slide the cover in the direction of the arrow to remove it.
21. REMOVE SHOULDER BELT ANCHOR COVER RH
HINT: Use the same procedures described for the LH side.

22. REMOVE REAR SEAT SIDE GARNISH LH
(a) Detach the 6 claws and remove the rear seat side garnish.
23. REMOVE REAR SEAT SIDE GARNISH RH
HINT: Use the same procedures described for the LH side.

24. REMOVE INNER ROOF SIDE GARNISH LH
(a) Pull the garnish away from the body and detach the 4 clips (do not detach clip A).
(b) Detach the 2 claws of the guide, and remove the inner roof side garnish toward the front of the vehicle (in the direction of the arrow).
HINT: Clip A remains attached to the body.

(c) Remove clip A from the vehicle body.
25. REMOVE INNER ROOF SIDE GARNISH RH
HINT: Use the same procedures described for the LH side.

26. REMOVE MAP LIGHT ASSEMBLY
(a) Using a screwdriver, detach the 2 claws and open the 2 covers.
HINT: Tape the screwdriver tip before use.

(b) Remove the 2 screws.
(c) Using a moulding remover, detach the 2 clips.
(d) Disconnect the 2 connectors and then remove the map light.

(e) w/ Sliding Roof:
Disconnect the drive gear connector.

27. REMOVE SPOT LIGHT LENS (w/ Rear Seat Entertainment System)
(a) Detach the 4 claws and remove the spot light lens.
28. REMOVE ROOF CONSOLE BOX ASSEMBLY (w/ Rear Seat Entertainment System)

(a) Remove the 2 screws.
(b) Detach the 6 clips and 2 claws.
(c) w/o Infrared Rays Sensor:
Disconnect the connector and then remove the roof console box.
(d) w/ Infrared Rays Sensor:
Disconnect the 2 connectors and then remove the roof console box.

29. REMOVE SPOT LIGHT ASSEMBLY (w/o Rear Seat Entertainment System)
(a) Using a moulding remover, detach the 4 claws.
(b) Disconnect the connector and then remove the spot light.
30. REMOVE REAR VANITY LIGHT ASSEMBLY
HINT: Use the same procedures to remove the vanity light on the other side.

(a) Using a screwdriver, detach the 4 claws and remove the lens.
HINT: Tape the screwdriver tip before use.

(b) Remove the 2 screws.
(c) Using a moulding remover, detach the claw.
(d) Disconnect the connector and then remove the vanity light.

31. REMOVE COAT HOOK
HINT: Use the same procedures to remove the hook on the other side.

(a) Remove the screw and coat hook.

32. REMOVE ROOF SIDE REGISTER BEZEL LH (w/ Rear Cooler)
(a) Remove the screw.
(b) Detach the claw and remove the roof side register.
33. REMOVE ROOF SIDE REGISTER BEZEL RH (w/ Rear Cooler)
HINT: Use the same procedures described for the LH side.

34. REMOVE ASSIST GRIP SUB-ASSEMBLY
HINT: Use the same procedures for the other 3 assist grips.

(a) Using a screwdriver, detach the 4 claws and remove the 2 assist grip covers.
HINT: Tape the screwdriver tip before use.

(b) Detach the 2 clips and remove the assist grip.

35. REMOVE VISOR BRACKET COVER
HINT: Use the same procedures to remove the cover on the other side.

(a) Using a moulding remover, detach the 4 claws and remove the visor bracket cover.

36. REMOVE VISOR ASSEMBLY LH
(a) Remove the 2 screws and visor.
37. REMOVE VISOR ASSEMBLY RH
HINT: Use the same procedures described for the LH side.

38. REMOVE VISOR HOLDER
HINT: Use the same procedures to remove the holder on the other side.

(a) Turn the visor holder approximately 45° and pull it out as shown in the illustration.
(b) Detach the 2 claws and remove the visor holder.

39. REMOVE FRONT WIPER ARM LH Removal

40. REMOVE FRONT WIPER ARM RH Removal

41. REMOVE HOOD TO COWL TOP SEAL Removal

42. REMOVE COWL TOP VENTILATOR LOUVER RH Removal

43. REMOVE FRONT FENDER TO COWL SIDE SEAL LH Removal

44. REMOVE FRONT FENDER TO COWL SIDE SEAL RH Removal

45. REMOVE COWL TOP VENTILATOR LOUVER PROTECTOR LH Removal

46. REMOVE COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY Removal

47. REMOVE CENTER ROOF DRIP SIDE FINISH MOULDING LH
(a) Remove the center roof drip side finish moulding .
48. REMOVE CENTER ROOF DRIP SIDE FINISH MOULDING RH
(a) Remove the center roof drip side finish moulding .
49. REMOVE RAIN SENSOR COVER
(a) w/o Driver Monitor Camera:
Remove the rain sensor cover Removal.
(b) w/ Driver Monitor Camera:
Remove the rain sensor cover Removal.
50. DISCONNECT RAIN SENSOR CONNECTOR
51. REMOVE INNER REAR VIEW MIRROR ASSEMBLY Removal

52. REMOVE OBJECT RECOGNITION CAMERA (w/ Driver Monitor Camera) Removal

53. REMOVE UPPER WINDSHIELD OUTSIDE MOULDING Removal

54. REMOVE WINDSHIELD GLASS Removal

55. REMOVE NO. 2 WINDSHIELD GLASS STOPPER Removal

56. REMOVE WINDSHIELD GLASS RETAINER Removal

57. REMOVE WINDSHIELD GLASS ADHESIVE DAM Removal

58. REMOVE WINDSHIELD GLASS SEAL Removal

59. CLEAN WINDSHIELD GLASS Removal

60. REMOVE NO. 1 WINDSHIELD GLASS STOPPER Removal

61. CLEAN VEHICLE BODY Removal

62. REMOVE ROOF HEADLINING ASSEMBLY

(a) Disconnect the roof wire connectors and detach each clamp from the front pillar.

(b) for Standard Type:
Detach the hook, 12 claws, 3 fasteners and 4 clips.

(d) w/ Rear Seat Entertainment System:
Detach the hook, 12 claws, 8 fasteners and 4 clips.

(e) Remove the roof headlining through the front of the vehicle.
63. REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP LH
64. REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP RH
65. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP LH
66. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP RH