Installation

SUPPLEMENTAL RESTRAINT SYSTEMS: CURTAIN SHIELD AIRBAG ASSEMBLY: INSTALLATION

SUPPLEMENTAL RESTRAINT SYSTEMS: CURTAIN SHIELD AIRBAG ASSEMBLY: INSTALLATION

1. INSTALL CURTAIN SHIELD AIRBAG ASSEMBLY
(a) Check that the engine switch is off.
(b) Check that the cable is disconnected from the negative (-) battery terminal.
CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

(c) Temporarily install the curtain shield airbag assembly with the 7 hooks.





NOTICE: Do not twist the curtain shield airbag assembly when installing it.

(d) Install the 2 clams.





(e) Install 9 new bolts.
Torque: 14 Nm (143 kgf-cm, 10 ft-lbf)
HINT: Tighten the bolt in order from 1 to 9.

(f) Connect the curtain shield airbag connector.
NOTICE: When connecting the airbag connector, take care not to damage the airbag wire harness.

2. INSTALL ROOF HEADLINING ASSEMBLY
HINT: Refer to the procedure from Install Roof Headlining Assembly Installation.