Parking Brake Switch Circuit

NAVIGATION / MULTI INFO DISPLAY: NAVIGATION SYSTEM: Parking Brake Switch Circuit

Parking Brake Switch Circuit

DESCRIPTION

This circuit is from the parking brake switch to the multi-display.

WIRING DIAGRAM





INSPECTION PROCEDURE

PROCEDURE

1. CHECK BRAKE WARNING LIGHT
(a) Check that the brake warning light comes on when the parking brake is applied and goes off when it is released.
OK:
The brake warning light operates as specified above.
NG -- INSPECT PARKING BRAKE SWITCH
OK -- Continue to next step.
2. CHECK HARNESS AND CONNECTOR (MULTI-DISPLAY - PARKING BRAKE SWITCH)





(a) Disconnect the multi-display connector and parking brake switch connector.





(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:






NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE
3. INSPECT PARKING BRAKE SWITCH





(a) Remove the parking brake switch.
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:






NG -- REPLACE PARKING BRAKE SWITCH
OK -- REPAIR OR REPLACE HARNESS OR CONNECTOR