AVC-LAN Circuit

NAVIGATION / MULTI INFO DISPLAY: NAVIGATION SYSTEM: AVC-LAN Circuit

AVC-LAN Circuit

DESCRIPTION

Each unit of the navigation system connected to the AVC-LAN (communication bus) transfers the Switch signals by communication.
When a short to +B or short to ground occurs in this AVC-LAN, the navigation system will not function normally as communication is stopped.

INSPECTION PROCEDURE

PROCEDURE

1. INSPECT RADIO RECEIVER
(a) Disconnect the radio receiver connectors.





(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:






NG -- REPLACE RADIO RECEIVER
OK -- Continue to next step.
2. CHECK HARNESS AND CONNECTOR
HINT:For details of the connectors, refer to Terminals of ECU Pinout Values and Diagnostic Parameters.
(a) Referring to AVC-LAN Wiring Diagram below, check all AVC-LAN circuits.
(1) Disconnect all connectors in all AVC-LAN circuits.
(2) Check for an open or short in all AVC-LAN circuits.
OK:
There are no open or short circuits.





NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.
3. INSPECT MALFUNCTIONING PARTS
(a) Disconnect each slave unit one by one to check if the master unit returns to normal operation. If the master unit does not return to normal operation, reconnect the disconnected slave unit and then check the other slave units.
OK:
Master unit returns to normal operation.
HINT:
- Check all slave units.
- If the master unit returns to normal operation after disconnecting a slave unit, there is a short in the slave unit. Therefore, replace the slave unit.

NG -- PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE
OK -- REPLACE MALFUNCTIONING PARTS