Stop Light Control Relay

LIGHTING: STOP LIGHT CONTROL RELAY:

INSPECTION

1. INSPECT STOP LIGHT CONTROL RELAY






(a) Disconnect the J89 stop light control relay connector.
(b) Measure the voltage according to the value(s) in the table below.
Standard voltage:





If the result is not as specified, there is a malfunction on the wire harness side.
(c) Measure the resistance according to the value(s) in the table below.
Standard resistance:





If the result is not as specified, there is a malfunction on the wire harness side.






(d) Reconnect the J89 stop light control relay connector.
(e) Measure the voltage according to the value(s) in the table below.
Standard voltage:





If the result is not as specified, replace the stop light control relay.