Installation

SUPPLEMENTAL RESTRAINT SYSTEM: SPIRAL CABLE: INSTALLATION

INSTALLATION

1. INSTALL SPIRAL CABLE






(a) Align the pins on the spiral cable with the installation holes on the steering sensor.
(b) Attach the 6 claws and install the spiral cable to the steering sensor.
2. INSTALL SPIRAL CABLE WITH STEERING SENSOR
(a) Check that the front wheels are facing straight ahead.
(b) Set the turn signal switch to the neutral position.
NOTE: If it is not in the neutral position, the pin of the turn signal switch may be snapped.





(c) Attach the 3 claws and install the spiral cable with steering sensor.
NOTE: When replacing the spiral cable with a new one, remove the lock pin before installing the steering wheel assembly.

(d) Connect the connectors to the spiral cable with steering sensor.
NOTE: When handling the airbag connector, take care not to damage the airbag wire harness.

3. INSTALL STEERING COLUMN COVER Installation

4. ADJUST SPIRAL CABLE WITH STEERING SENSOR
(a) Check that the power switch is OFF.
(b) Check that the battery negative (-) terminal is disconnected.
CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.





(c) Rotate the spiral cable with steering sensor counterclockwise slowly by hand until it feels firm.
NOTE: Do not turn the spiral cable with steering sensor by the airbag wire harness.





(d) Rotate the spiral cable with steering sensor clockwise approximately 2.5 turns to align the marks.
NOTE: Do not turn the spiral cable with spiral sensor by the airbag wire harness.
HINT: The spiral cable with steering sensor will rotate approximately 2.5 turns to both the left and right from the center.

5. INSTALL STEERING WHEEL ASSEMBLY Installation

6. INSPECT STEERING WHEEL CENTER POINT
7. INSTALL STEERING PAD Installation

8. INSTALL NO. 3 STEERING WHEEL COVER LOWER
9. INSTALL NO. 2 STEERING WHEEL COVER LOWER
10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
11. INSPECT STEERING PAD Installation

12. PERFORM INITIALIZATION
(a) Perform initialization Repair Instruction - Initialization.
NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.

13. CHECK SRS WARNING LIGHT
(a) Check the SRS warning light Diagnosis System.