Rear Door Window Glass

Rear Door Window Glass

Removal
1 Remove the rear door window motor and regulator assembly. For additional information, refer to Rear Door Window Regulator and Motor Service and Repair
2 Lower the rear door glass to the bottom of the door.
- Remove the wedge.




3 Carefully remove the inner waist seal.
- Release it from 3 clips.




4 Position the rear edge of the glass, forward of the glass guide channel.
- Release the lining from the glass rear guide channel.




5 Remove the rear door window glass.
- Release the lining from the glass front guide channel.




6
NOTE:
Do not disassemble further if the component is removed for access only.
NOTE:
Note the fitted position.
Remove the glass retaining clip.
- Remove the Torx bolt.
- Remove the spacer washer.
- Remove the flat washer.

Installation
1 Install the glass retaining clip.
- Install the spacer.
- Install the washer.
- Tighten the Torx screws to 8 Nm (6 lb.ft).
2 Install the rear door window glass.
3 Install the guide channel lining.
4 Install the inner waist seal.
5
NOTE:
Wedge the glass in this position.
Raise the rear door glass fully.
6 Install the rear door window motor and regulator assembly. For additional information, refer to Rear Door Window Regulator and Motor Service and Repair