Electronic Brake Control Module: Service and Repair

Anti-Lock Brake System (ABS) Module
This is a "Trustmark Authoring Standards (TAS) Repair Procedure"
- TAS style procedures can be identified by steps that have no accompanying step text and the magenta color of the electrical connectors and fasteners such as nuts, bolts, clamps or clips.
- TAS removal and installation procedures use a sequence of color illustrations to indicate the order to be followed when removing/disassembling or installing/assembling a component.
- Many of the TAS procedures will have the installation information within the removal steps.
- The TAS color illustrations use a variety of symbols to indicate important details of the procedures. It is important to understand these symbols in order to properly used the TAS procedures.
Refer to How to Use TAS Procedures and TAS Symbol Glossary at Vehicle | Description and Operation for additional information on these TAS procedures.
For additional information, refer to How to Use TAS Procedures How to Use TAS Procedures

Removal

CAUTION: If brake fluid is spilt on the paintwork, the affected area must be immediately washed down with cold water.

CAUTION: Make sure that all openings are sealed. Use new blanking caps.

NOTE:
Removal steps in this procedure may contain installation details.

NOTE:
LHD illustration shown, RHD is similar.

All vehicles

WARNING: Make sure to support the vehicle with axle stands.
1 Raise and support the vehicle.
For additional information, refer to Plenum Chamber Plenum Chamber
For additional information, refer to Battery Tray Service and Repair

Vehicles with petrol engine





Vehicles with diesel engine





All vehicles
















M6: 10 Nm
M8: 25 Nm





WARNING: Fluid loss is unavoidable, use absorbent cloth or a container to collect the fluid.

Torque to: 17 Nm









Torque to: 14 Nm





Torque to: 9 Nm





NOTE:
Do not disassemble further if the component is removed for access only.

Torque to: 9 Nm

Installation

NOTE:
Remove and discard all blanking caps.
1 To install, reverse the removal procedure.
For additional information, refer to Brake System Pressure Bleeding Brake System Pressure Bleeding
2 If a new component has been installed, configure using Land Rover approved diagnostic equipment.