D-Pillar Trim Panel

D-Pillar Trim Panel

Removal
1 Remove the lower quarter trim panel. For additional information, refer to Rear Quarter Trim Panel Rear Quarter Trim Panel




2
NOTE:
Left-hand shown, right-hand similar.
With assistance, remove the rear seat assembly.
- Remove and discard the 7 Torx bolts.
- Disconnect the electrical connector.




3 Remove the safety belt lower anchor.
- Remove and discard the Torx bolt.




4 Remove the D-pillar trim panel.
- Release the 4 clips.
- Release the safety belt from the trim panel.




5
NOTE:
Do not disassemble further if the component is removed for access only.
Remove the 4 clips from the D-pillar upper trim panel.

Installation
1 Install the clips to the D-pillar upper trim panel.
2 Install the D-pillar upper trim panel.
- Position the safety belt through the trim panel.
- Secure the clips.
3 Install the safety belt lower anchor.
- Tighten the Torx bolt to 45 Nm (33 lb.ft).
4 With assistance, install the rear seat assembly.
- Position the locating pegs.
- Connect and secure the electrical connector.
- Tighten the Torx bolts to 40 Nm (30 lb.ft).
5 Install the lower quarter trim panel For additional information, refer to Rear Quarter Trim Panel Rear Quarter Trim Panel