Front Bumper Cover

Front Bumper Cover
This is a "Trustmark Authoring Standards (TAS) Repair Procedure"
- TAS style procedures can be identified by steps that have no accompanying step text and the magenta color of the electrical connectors and fasteners such as nuts, bolts, clamps or clips.
- TAS removal and installation procedures use a sequence of color illustrations to indicate the order to be followed when removing/disassembling or installing/assembling a component.
- Many of the TAS procedures will have the installation information within the removal steps.
- The TAS color illustrations use a variety of symbols to indicate important details of the procedures. It is important to understand these symbols in order to properly used the TAS procedures.
Refer to How to Use TAS Procedures and TAS Symbol Glossary at Vehicle | Description and Operation for additional information on these TAS procedures.
For additional information, refer to How to Use TAS Procedures How to Use TAS Procedures
For additional information, refer to TAS Symbol Glossary TAS Symbols Glossary
Removal

NOTE:
Removal steps in this procedure may contain installation details.

NOTE:
The ignition must be switched off.
For additional information, refer to Battery Disconnect and Connect Battery Disconnect and Connect

WARNING: Make sure to support the vehicle with axle stands.
1 Raise and support the vehicle.
2 Remove both the front wheels and tires.
For additional information, refer to Wheel and Tire Service and Repair




1: 7 Nm
2: 3.2 Nm





NOTE:
RH illustration shown, LH is similar.

NOTE:
The procedure must be carried out on both sides.

Torque to: 1.5 Nm













NOTE:
RH illustration shown, LH is similar.

NOTE:
The procedure must be carried out on both sides.

Torque to: 3.2 Nm





Torque to: 1.9 Nm









CAUTION: Make sure that the clips are correctly located.

NOTE:
Do not disassemble further if the component is removed for access only.

Torque to: 7 Nm





NOTE:
The procedure must be carried out on both sides.

NOTE:
RH illustration shown, LH is similar.

Torque to: 3.2 Nm





NOTE:
RH illustration shown, LH is similar.

NOTE:
The procedure must be carried out on both sides.





NOTE:
RH illustration shown, LH is similar.

NOTE:
The procedure must be carried out on both sides.





NOTE:
LH illustration shown, RH is similar.

NOTE:
The procedure must be carried out on both sides.

Torque to: 1.5 Nm





CAUTION: Protect the surrounding paintwork to avoid damage.

CAUTION: Take extra care not to damage the clips.

Torque to: 1.5 Nm









NOTE:
RH illustration shown, LH is similar.

NOTE:
The procedure must be carried out on both sides.

Torque to: 1.5 Nm





CAUTION: Take extra care not to damage the clips.





NOTE:
Take note of the routing.





NOTE:
RH illustration shown, LH is similar.

NOTE:
The procedure must be carried out on both sides.





CAUTION: Make sure the locating dowels are installed correctly.

NOTE:
RH illustration shown, LH is similar.

NOTE:
The procedure must be carried out on both sides.





NOTE:
Make sure the wiring harness is routed correctly.





Installation
1 To install, reverse the removal procedure.