Front Door Window Regulator: Service and Repair

Front Door Window Regulator

Removal
1 Raise the window glass.
2 Remove the cover and disconnect the battery ground cable. For additional information, refer to Specifications
3 Remove the front door trim panel. For additional information, refer to Front Door Trim Panel Service and Repair




4 Remove the window regulator motor.
- Disconnect the electrical connector.
- Remove the 3 Torx screws.




5 Release the front door inner weathershield.
- Disconnect the 3 electrical connectors.
- Release the 9 wiring harness clips.




6 Remove the front door inner weathershield.
- Remove the 12 Torx bolts.
- Release the front door interior handle cable.
7 Carefully remove the outer waist seal.
- Release each end of the seal from the door frame.




8 Remove the front door window glass.
- Remove the 2 Torx bolts.
- Collect the clamp and rubber washer.
9 Remove the window regulator assembly.
- Release the rubber lining from the glass channel.
- Remove the 4 Torx screws.
- Remove the bolt.
- Remove the nut.

Installation
1 Install the window regulator assembly.
- Tighten the nut to 10 Nm (7 lb.ft).
- Tighten the bolt to 10 Nm (7 lb.ft).
- Install and tighten the Torx screws.
- Install the rubber lining to the glass channel.
2 Install the front door window glass.
- Attach the clamp and rubber washer.
- Install the Torx bolts, but do not tighten fully at this stage.
3 Install the outer waist seal.




4
NOTE:
The window must be fully raised when carrying out measurements.
Align the front door window glass longitudinally.
- Position the window, forwards or rearwards, glass edge should be 44mm from edge of door as shown in dimension 'A'.
- Tighten the Torx bolts to 8 Nm (6 lb.ft).




5
NOTE:
To adjust the window hold the locknut and turn the centre spindle.
Align the front door window glass horizontally.
- Release the retaining nut.
- Align the glass to door, glass should be 12mm from door as shown in dimension 'B'.
- Tighten the retaining nut to 10 Nm (7 lb.ft).
6 Install the front door inner weathershield.
- Attach the front door interior handle cable.
- Tighten the Torx bolt to 10 Nm (7 lb.ft).
7 Secure the front door inner weathershield.
- Secure the wiring harness clips.
- Connect the electrical connectors.
8 Install the window regulator motor.
- Install and tighten the Torx screws.
- Connect the electrical connector.
9 Install the front door trim panel. For additional information, refer to Front Door Trim Panel Service and Repair

10 Connect the battery ground cable and install the cover. For additional information, refer to Specifications