Removal and Replacement

Driveshaft
This is a "Trustmark Authoring Standards (TAS) Repair Procedure"
- TAS style procedures can be identified by steps that have no accompanying step text and the magenta color of the electrical connectors and fasteners such as nuts, bolts, clamps or clips.
- TAS removal and installation procedures use a sequence of color illustrations to indicate the order to be followed when removing/disassembling or installing/assembling a component.
- Many of the TAS procedures will have the installation information within the removal steps.
- The TAS color illustrations use a variety of symbols to indicate important details of the procedures. It is important to understand these symbols in order to properly used the TAS procedures.
Refer to How to Use TAS Procedures and TAS Symbol Glossary at Vehicle | Description and Operation for additional information on these TAS procedures.
For additional information, refer to How to Use TAS Procedures How to Use TAS Procedures
For additional information, refer to TAS Symbol Glossary TAS Symbols Glossary
Removal

NOTE:
Select NEUTRAL before disconnecting the battery, to allow the driveshaft to be turned.
For additional information, refer to Battery Disconnect and Connect Battery Disconnect and Connect

WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
1 Raise and support the vehicle.
For additional information, refer to Exhaust System Service and Repair

















CAUTION: Under no circumstances must the flexible coupling (or it's fixings) be loosened or removed from the driveshaft.





CAUTION: To avoid damage to the joint or gaiter, do not allow the driveshaft to hang.

NOTE:
Make sure that the special tool is correctly installed to the recess on the driveshaft.

Special Service Tool




Remover, Driveshaft, 205-932





CAUTION: To avoid damage to the joint or gaiter, do not allow the driveshaft to hang.

NOTE:
Using a suitable hammer and drift, make sure that you only hit the corner edges of the special tool to remove the driveshaft.

Special Service Tool




Remover, Driveshaft, 205-932





Installation






CAUTION: Only tighten the bolts finger-tight at this stage.





NOTE:
Make sure that the alignment mark on the driveshaft is correctly aligned to the alignment mark on the differential case.

Torque to: 75 Nm





NOTE:
This step only applies if a new driveshaft is being installed.

NOTE:
Using the 3mm hole on the differential case flange and paint alignment mark on the driveshaft (as indicated). Make sure that the alignment marks are correctly aligned.

Torque to: 75 Nm





CAUTION: Under no circumstances must the flexible coupling (or it's fixings) be loosened or removed from the driveshaft.

Torque to: 127 Nm





Torque to: 40 Nm





Torque to: 5 Nm





Torque to: 7 Nm





Torque to: 10 Nm
For additional information, refer to Exhaust System Service and Repair

WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
1 Lower the vehicle.
For additional information, refer to Battery Disconnect and Connect Battery Disconnect and Connect