Tire Pressure Monitoring System Rear Antenna

Tire Pressure Monitoring System Rear Antenna

Removal
1 Disconnect the battery ground cable. For additional information, refer to Specifications
2
WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
Raise and support the vehicle.
3 Remove the LH rear wheel and tire. For additional information, refer to Wheel and Tire Service and Repair




4 Release the rear lower edge of the rear fender splash shield.
- Remove the 5 Torx bolts.
- Tie the splash shield aside.




5 Remove the tire pressure antenna.
- Disconnect the electrical connector.
- Remove the 2 clips.

Installation
1 Install the tire pressure antenna.
- Install the clips.
- Connect the electrical connector.
2 Install the fender splash shield.
- Tighten the Torx bolts.
3 Install the wheel and tire assembly. For additional information, refer to Wheel and Tire Service and Repair
4 Connect the battery ground cable. For additional information, refer to Specifications