Brake Booster [LHD]

Brake Booster

Removal
1 Remove the brake master cylinder. For additional information, refer to Brake Master Cylinder - LHD Brake Master Cylinder [LHD]




2
CAUTION: Removal of the clips is a delicate procedure, damage will occur if any force is used.
Remove the driver's side footwell trim panel.
- Carefully release the 3 clips.




3 Release the brake switch.
- Rotate clockwise approximately 30 degrees.




4 Release the vacuum pipe.




5 Remove the brake booster.
- Remove the brake pedal clevis pin.
- Remove the 4 nuts.
6 Remove and discard the gasket.

Installation
1 Install new gaskets.
2 Install the brake booster.
- Tighten the nuts to 25 Nm (18 lb.ft).
- Install the brake pedal clevis pin.
3 Connect the vacuum hose.
4 Install the brake switch.
5 Install the driver's side footwell trim panel.
- Carefully align and secure the clips.
6 Install the brake master cylinder. For additional information, refer to Brake Master Cylinder - LHD Brake Master Cylinder [LHD]