Windshield Wiper Pivot Arm

Windshield Wiper Pivot Arm
This is a "Trustmark Authoring Standards (TAS) Repair Procedure"
- TAS style procedures can be identified by steps that have no accompanying step text and the magenta color of the electrical connectors and fasteners such as nuts, bolts, clamps or clips.
- TAS removal and installation procedures use a sequence of color illustrations to indicate the order to be followed when removing/disassembling or installing/assembling a component.
- Many of the TAS procedures will have the installation information within the removal steps.
- The TAS color illustrations use a variety of symbols to indicate important details of the procedures. It is important to understand these symbols in order to properly used the TAS procedures.
Refer to How to Use TAS Procedures and TAS Symbol Glossary at Vehicle | Description and Operation for additional information on these TAS procedures.
For additional information, refer to How to Use TAS Procedures How to Use TAS Procedures
For additional information, refer to TAS Symbol Glossary TAS Symbols Glossary
Removal

CAUTION: Always protect paintwork and glass when removing exterior components.









NOTE:
Do not disassemble further if the component is removed for access only.

Installation
1 Install the wiper blade.





CAUTION: Align the wiper blades onto the centre of the windshield circle mark.

NOTE:
After the wiper pivot arm nuts have been tightened to the correct torque value, lift the wiper pivot arm from the windshield and return to the windshield. Make sure that wiper blades are not positioned below any point of the windshield circle mark.





Torque to: 22 Nm