Tire Pressure Monitor Receiver / Transponder: Service and Repair

Tire Pressure Monitoring System Receiver
This is a "Trustmark Authoring Standards (TAS) Repair Procedure"
- TAS style procedures can be identified by steps that have no accompanying step text and the magenta color of the electrical connectors and fasteners such as nuts, bolts, clamps or clips.
- TAS removal and installation procedures use a sequence of color illustrations to indicate the order to be followed when removing/disassembling or installing/assembling a component.
- Many of the TAS procedures will have the installation information within the removal steps.
- The TAS color illustrations use a variety of symbols to indicate important details of the procedures. It is important to understand these symbols in order to properly used the TAS procedures.
Refer to How to Use TAS Procedures and TAS Symbol Glossary at Vehicle | Description and Operation for additional information on these TAS procedures.
For additional information, refer to How to Use TAS Procedures How to Use TAS Procedures
For additional information, refer to TAS Symbol Glossary TAS Symbols Glossary
Removal

NOTE:
Removal steps in this procedure may contain installation details.

NOTE:
The tire pressure monitoring system receiver is installed in the same location on both LHD and RHD vehicles.
1 Switch the ignition off.
2 Remove the left-hand floor console side trim panel.
For additional information, refer to Floor Console Side Trim Panel Floor Console Side Trim Panel









Installation
1 To install, reverse the removal procedure.
2 Configure the tire pressure monitoring system using the diagnostic tool.