Fuel Pump and Sender Unit

Fuel Pump and Sender Unit
This is a "Trustmark Authoring Standards (TAS) Repair Procedure"
- TAS style procedures can be identified by steps that have no accompanying step text and the magenta color of the electrical connectors and fasteners such as nuts, bolts, clamps or clips.
- TAS removal and installation procedures use a sequence of color illustrations to indicate the order to be followed when removing/disassembling or installing/assembling a component.
- Many of the TAS procedures will have the installation information within the removal steps.
- The TAS color illustrations use a variety of symbols to indicate important details of the procedures. It is important to understand these symbols in order to properly used the TAS procedures.
Refer to How to Use TAS Procedures and TAS Symbol Glossary at Vehicle | Description and Operation for additional information on these TAS procedures.
For additional information, refer to How to Use TAS Procedures How to Use TAS Procedures
For additional information, refer to TAS Symbol Glossary TAS Symbols Glossary
Removal

NOTE:
Removal steps in this procedure may contain installation details.

WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
1 Raise and support the vehicle.

























Special Service Tool




Locking Ring, Fuel Tank, 310-123





NOTE:
Note the position of the locating tang.

NOTE:
Remove and discard the O-ring seal.





CAUTION: Take extra care not to damage the fuel tank level sensor float and arm.

Installation

CAUTION: Take extra care not to damage the fuel tank level sensor float and arm.

CAUTION: Make sure the fuel pump and sender unit is correctly installed in to the retaining bracket in the fuel tank.

NOTE:
Make sure the locating tang is installed in the correct position.
1 To install, reverse the removal procedure.