Floor Console Side Trim Panel

Floor Console Side Trim Panel
This is a "Trustmark Authoring Standards (TAS) Repair Procedure"
- TAS style procedures can be identified by steps that have no accompanying step text and the magenta color of the electrical connectors and fasteners such as nuts, bolts, clamps or clips.
- TAS removal and installation procedures use a sequence of color illustrations to indicate the order to be followed when removing/disassembling or installing/assembling a component.
- Many of the TAS procedures will have the installation information within the removal steps.
- The TAS color illustrations use a variety of symbols to indicate important details of the procedures. It is important to understand these symbols in order to properly used the TAS procedures.
Refer to How to Use TAS Procedures and TAS Symbol Glossary at Vehicle | Description and Operation for additional information on these TAS procedures.
For additional information, refer to How to Use TAS Procedures
For additional information, refer to TAS Symbols Glossary
Removal

NOTE:
LHD right-hand floor console side trim panel shown, LHD left-hand and both RHD floor console side trim panels are similar.

NOTE:
Removal steps in this procedure may contain installation details.
1 Recline the front seats and move to the rear most position.





NOTE:
When removing the component, some of the clips may remain attached. These clips should be removed and returned to their original positions in the instrument panel.





















NOTE:
When removing the component, some of the clips may remain attached. These clips should be removed and returned to their original positions in the center console.













NOTE:
Do not disassemble further if the component is removed for access only.





Installation

NOTE:
Make sure that the veneer trim panel is correctly installed and secured.
1 To install, reverse the removal procedure.