Removal and Installation

BODY SIDE TRIM

Removal and Installation


CAUTION:
- When removing, always use a remover tool that is made of plastic.
- Never damage the body.

REMOVAL

Front Pillar Garnish
1.Release front pillar portion of body side welt.





2.Disengage front pillar garnish fixing anchor clip and metal clip using a remover tool (A).










3.Cut anchor clip portion.
4.Remove front pillar garnish, and then remove anchor clip from body panel.
Dash Side Finisher
1.Remove instrument passenger lower cover.
Refer to "A/T MODELS : Removal and Installation" Removal and Installation A/T Models (A/T models).
Refer to "M/T MODELS : Removal and Installation" Removal and Installation M/T Models (M/T models).
2.Remove kicking plate inner.





3.Remove clip (A).
4.Remove dash side finisher fixing clips using a remover tool (B), and then remove dash side finisher (1).





Kicking Plate Outer





Remove kicking plate outer fixing clips using a remover tool (A), and then remove kicking plate outer (1).





Kicking Plate Inner
1.Disengage kicking plate inner fixing pawl on portion (A) as shown in the figure using a remover tool (D).
2.Disengage kicking plate inner fixing pawls on portion (B) as shown in the figure using a remover tool (D).

CAUTION:
Apply protective tape (E) on the parts to protect it from damage.
3.Pull kicking plate inner toward vehicle rear while pressing front end of kicking plate inner downward, disengage kicking plate inner fixing pawl on portion (C) as shown in the figure, and then remove kicking plate inner.










Body Side Welt
1.Remove kicking plate inner.
2.Remove body side welt.
Rear Side Finisher
1.Remove rear seat cushion and rear seatback. Refer to "Removal and Installation" Removal and Installation.
2.Remove body side welt.





3.Remove rear side finisher (1) fixing clips using a remover tool (A), and then disconnect rear speaker harness connector.





4. Remove rear side finisher.
Back Pillar Garnish





1.Remove back pillar garnish (1) fixing clips and pawls using a remover tool (A).
2.Remove back pillar garnish (1) from rear pillar finisher (2).





Rear Pillar Finisher
1.Remove rear seat cushion and rear seatback. Refer to "Removal and Installation" Removal and Installation.
2.Remove body side welt.
3.Remove rear side finisher.
4.Remove front seat belt floor anchor bolt. Refer to "SEAT BELT BUCKLE : Exploded View" Exploded View.
5.Remove rear seat belt floor anchor bolt. Refer to "SEAT BELT BUCKLE : Exploded View" Exploded View.





6.Remove rear seat belt escutcheon fixing pawls using a remover tool (A), and then remove rear seat belt escutcheon (1) from rear pillar finisher (2).





7.Remove back pillar garnish.
8.Remove rear pillar finisher fixing clips, pawl, metal clips using a remover tool, and then remove rear pillar finisher.

INSTALLATION

Note the following items, and then install in the reverse order of removal.

CAUTION:
- Always replace anchor clips with a new one after every removal.
- When installing, check in advance that clips, pawls and metal clips are accurately aligned with the holes on body panel, and then install by pressing in.