Center Pillar Lower Garnish

BODY SIDE TRIM

CENTER PILLAR LOWER GARNISH : Removal and Installation


CAUTION:
- When removing, always use a remover tool that is made of plastic.
- Never damage the body.

REMOVAL

1.Remove front kicking plate inner and rear kicking plate inner. Kicking Plate Inner.





2.Insert a remover tool between body panel and center pillar lower garnish to disengage the fixing clips and pawls as shown in the figure.





3.Pull back center pillar lower garnish to remove.

INSTALLATION

Note the following item, and then install in the reverse order of removal.

CAUTION:
Check that clips are securely fitted in panel holes on body when installing, and then press clips in.