Removal and Installation

IGNITION COIL, SPARK PLUG AND ROCKER COVER

Removal and Installation


REMOVAL

1.Remove engine cover. Exploded View.
2.Remove air cleaner case and air duct (bank 1 and bank 2). Service and Repair.
3.Remove intake manifold collector. Exploded View.
4.Disconnect PCV hose from rocker cover.
5.Remove PCV valve and O-ring from rocker cover, if necessary.
6.Remove camshaft position sensor and exhaust valve timing control position sensor.

CAUTION:
Never shock camshaft position sensor and exhaust valve timing control position sensor.
7.Remove oil filler cap from rocker cover, if necessary.
8.Remove ignition coil.

CAUTION:
Never shock ignition coil. Failure to do this may cause damage to the parts.





9.Loosen bolts in reverse order shown in the figure.





10.Remove rocker cover gasket from rocker cover.

INSTALLATION






1.Apply liquid gasket to the position shown in the figure with the following procedure:





Use Genuine Liquid Gasket or equivalent.
a.Refer to figure (E) to apply liquid gasket to joint part of camshaft bracket (No.1) (1) and cylinder head.
b.Refer to figure (H) to apply liquid gasket in 90 degrees to figure.
2.Install rocker cover gasket to rocker cover.
3.Install rocker cover.
- Check that rocker cover gasket does not drop from the installation groove of rocker cover.





4.Tighten bolts in two steps separately in numerical order as shown in the figure.