Special Repair Requirement

MEMORY STORING

Special Repair Requirement


Memory Storage Procedure

Two positions for the driver seat, steering column and outside mirror can be stored for memory operation by following procedure.

1. STEP 1

Check the following conditions.
- Ignition switch : ON
- A/T selector lever : P position
- GO TO 2.

2. STEP 2

Adjust driver seat, steering column and outside mirror position manually.
- GO TO 3.

3. STEP 3

1.Push set switch.
NOTE:
- Memory indicator for which driver seat position is already retained in memory is illuminated for 5 seconds.
- Memory indicator for which driver seat position is not retained in memory is illuminated for 0.5 second.
2.Push the memory switch (1 or 2) for at least 1 second within 5 seconds after pushing the set switch.
NOTE:
- To enter driver seat positions into blank memory, memory indicator will be turned on for 5 seconds.
- To modify driver seat positions, memory indicator will be turned OFF for 0.5 second, then turned ON for
5 seconds.
NOTE:
If memory is stored in the same memory switch, the previous memory will be deleted.
- GO TO 4.

4. STEP 4

Confirm the operation of each part with memory operation.
- END