Removal and Installation

PERSONAL LAMP

Removal and Installation


CAUTION:
Disconnect the battery negative terminal or remove the fuse.

REMOVAL

1.Insert any appropriate tool into the gap between the lens. Remove the lens.





2.Press the both side pawls (A) to the arrow direction ().
Remove the personal lamp finisher.
NOTE:
Replace the personal lamp case as a set (right and left). Remove the personal lamp case after installing the headlining assembly. Refer to
Exploded View (normal roof), Exploded View (sun roof).

INSTALLATION

Install in the reverse order of removal.
NOTE:
The following is easier to install the personal lamp finisher with the headlining installed.





- Press the personal lamp finisher to the headlining. Pull the personal lamp case pawl to the arrow direction () with any appropriate tool.