Removal and Installation

CENTER CONSOLE ASSEMBLY

M/T MODELS : Removal and Installation


CAUTION:
When removing, always use a remover tool that is made of plastic.

REMOVAL

1.Remove shift lever knob. Removal and Installation.
2.Remove console finisher.





- Remove metal clips from rear of console finisher, and then remove pawl of front.
- Pull console finisher upward to disengage from center console assembly.
- Disconnect harness connectors.










3.Remove coin pocket fixing pawl using a remover tool (A), and then remove coin pocket (1).





4.Remove console rear finisher.





- Pull back the console rear finisher (1).
- Disconnect inside key antenna connector (A).





5.Remove console mask.





- Open the console lid.
- Pull up console mask by using a remover tool (C), and disengage pawls.





6.Remove center console assembly.





- Remove screws (B) of center console assembly front side with screw driver (A).





- Disconnect console sub harness connectors (A).





- Disconnect heated seat switch connector (A). (with heated seat)





- Insert a deep-well socket wrench (A) to rotate adjusting nut to loosen cable sufficiently. Lever Type.





- Remove screws (C) of center console assembly rear side, and then remove center console assembly.

INSTALLATION

Install in the reverse order of removal.